Find studs in the wall where the curio cabinets will crash. Driving a nail into the wall to check to make sure you have found a stud and no plumbing or other object. Mark each stud with a pencil mark. Place the top of a table of 2 by 4 inches along the line to create a table ledger. Drive a screw through cover plate ledger on a stallion. The primary beam can support the weight of the box during installation curio cabinets. Repeat on the adjacent wall. Measure and mark points along the back of the cabinet, where the cabinet will rest against a post. Make a hole in the side of the bar to hang a stallion will meet. The hanging rails are areas on the top and bottom of the reinforced box.
Lift the curio cabinets and place the lower rear shelf so that it rests on the ledger. Have a friend hold the curio cabinet on the wall. Open the doors to the cabinet of curiosities and drive a screw through the pre-drilled into a wall stud holes. Repeat for all pre-drilled holes. Loosen the advice ledger wall. Wall paster with putty.